EXOTHERM
CORPORATION
 
 
 
 

UNIFLUX HEATERS

CLICK ON AN IMAGE TO SEE A LARGER VIEW.
 

Process Heater in West Texas

The Gunnison Platform

Control panel on a multiphase heater

Preparing to test fire a multiphase heater

 Fabricating a heater - note the softwall insulation and liner Gunnison Platform - Exotherm's heater and pumpskid are on the left of the lower level.
Close-up of Uniflux heater on the Gunnison Platform A pump skid for use on a Kerr McGee offshore platform Readying a pumpskid for disassembly and shipment.
Testing a heater for Kerr McGee's Constitution Platform Testing two Hot Oil and two Regen Gas Heaters for Atlantic LNG Shipping a Hot Oil Heater
Testing two Regen Gas Heaters and preparing to ship a Hot Oil Heater A burner skid in shipping prep.  The panel will be shrink wrapped before shipping. Shipping a hot oil heater. This one is going to Egypt. Notice the burner skid in the background.
A heater leaving the fabrication plant. Finishing functional tests.  Notice the fuel line and prominent process header. Process heater ready for disassembly and shipment.
A smaller, down-fired heater. Regeneration Gas heaters.  These units have redundant combustion air blowers. Six Rectangular Uniflux heaters of various ages, in Philadelphia
A four pass coil awaiting removal of shipping bracing and installation into a heater. A small diameter, down-fired heater.  The blower motor starter is in the enclosure on the right. A regeneration gas heater in a plant.
 

 
 

Exotherm Corporation
888 Wilcrest Drive
Houston, Tx 77042

ph.:  713-981-9100
fax:  713-981-7081
info@exotherm.com

For service, call the above numbers

or send email to:   service@exotherm.com

 

HOME    PROCESS    HEAT TRANSFER    Q-PAK    OIL TOOL    TECHNICAL POINTS   SPECIFICATION    RFQ   INFO    ABOUT US    JOBS