EXOTHERM
CORPORATION
 
 
 
  The Q-Pak heater is ideal for heating air streams when the products of combustion can be mixed with the process air stream.  In this heater, the burner is mounted inline in the flow path of the combustion air.  As the process air flows over the burner, it supplies the combustion air necessary for the burner to operate.  If the air flow is not sufficient to maintain burner operation, an external blower can be supplied.  Fuel is piped into the burner, where it mixes with the combustion (process) air.  The resultant flame heats the air stream with very high efficiencies.


     Typical Applications       
Milling Applications
Mild Drying Applications
Kiln Heating
 
 


 

     Technical Specifications      
Designs from 0.1 to 5.0 MMBtu/hr
Efficiencies to 99%
Process Temperatures to 1000°F
 

A Q-Pak heater is being tested prior to shipment.  The burner is inside the flange on the side of the heater at the top.  On top of the heater is the blower, and the bottom flange is the discharge.  This is connected to the customer duct work.  Notice that the control panel is skid mounted, and can be located away from the heater.
 

 
 

Exotherm Corporation
888 Wilcrest Drive
Houston, Tx 77042

ph.:  713-981-9100
fax:  713-981-7081
info@exotherm.com

For service, call the above numbers

or send email to:   service@exotherm.com
 

HOME    PROCESS   HEAT TRANSFER    OIL TOOL   TECHNICAL POINTS    SPECIFICATION    RFQ   INFO   ABOUT US   GALLERY   JOBS